MakerLab创客实验室 — Let's Make something.
现在注册
已注册用户请 登入
MakerLab创客实验室 — Let's Make something.
现在注册
已注册用户请 登入
Ed large avatar

Ed

MakerLab创客实验室 第 148 号会员, 加入于 2014-06-20 07:34:49 AM
Ed 收藏的学习
Ed 收藏的话题
Ed 最近创建的学习教程
Ed 最近创建的话题
Mount for Mega Controller
模型分享/设计   •   4 年前   •   最后回复来自 Andy
1
Display pins
电子部分   •   4 年前   •   最后回复来自 Ed
7
Ed 最近的回复
4 年前
回复了 Ed 创建的话题 Display pins
@ShreddinPB Do you still need this info? I do have mine working and had put it away till I finished building my latest printer. It has been a few months since I worked on it, but if you still need this info, I can put together the correct pin configuration for you. May take me a couple days. (don't want to go through it if you are no longer in need.)

@Andy I never thanked you for the assistance. Thank you! I do appreciate it.
Ed
5 年前
回复了 Ed 创建的话题 Display pins
@Andy, I think I have the last 2 pins figured out. Can you confirm if they are correct? The Mega Controller display pins:

LCDA0 = RS
LCDSS = CS
RESET = RST

Using hardware/software spi (u8glib 12864 ST7920)
Thank you!
Ed
5 年前
回复了 Ed 创建的话题 Display pins
In the picture of the Mega Controller's LCD/SD port it shows "LCDSS". I can't find any reference to it in the firmware. Is it possible it is "LCDCS" (#define DOGLCD_CS 45).
I am trying to connect a Graphic LCD 12864 Smart Controller to your Mega Controller and cannot seem to figure out what the "LCDSS" pin would connect too.
This is the one http://reprap.org/wiki/RepRapDiscount_Full_Graphic_Smart_Controller I am trying to convert the 2 10 pin connectors to match the mega controller's port.
Any help is appreciated!
Ed