MakerLab创客实验室 — Let's Make something.
现在注册
已注册用户请 登入
copychuan large avatar
MakerLab创客实验室  ›  固件

打印机归零,碰到限位开关就停住了,不会像正常那样碰两次。

By copychuan at 7 个月前 , 499 次浏览

我配置的限位开关是这样的
#define ENDSTOPPULLUPS // Comment this out (using // at the start of the line) to disable the endstop pullup resistors

#ifndef ENDSTOPPULLUPS
// fine Enstop settings: Individual Pullups. will be ignord if ENDSTOPPULLUPS is defined
//#define ENDSTOPPULLUP_XMAX
//#define ENDSTOPPULLUP_YMAX
#define ENDSTOPPULLUP_ZMAX
#define ENDSTOPPULLUP_XMIN
#define ENDSTOPPULLUP_YMIN
//#define ENDSTOPPULLUP_ZMIN
#endif

#ifdef ENDSTOPPULLUPS
//#define ENDSTOPPULLUP_XMAX
//#define ENDSTOPPULLUP_YMAX
#define ENDSTOPPULLUP_ZMAX
#define ENDSTOPPULLUP_XMIN
#define ENDSTOPPULLUP_YMIN
//#define ENDSTOPPULLUP_ZMIN
#endif
是不是因为把几个关掉了呢?
这几个的具体意思是什么呢?

目前尚无回复